BARIX Streaming Client Guia do Utilizador descarregar pdf (Página 6)

2 Reflector Client firmware

2.1 Loading the STL firmware and selecting the Reflector.

To use the Reflector Service, all devices must have the STL firmware loaded: this is a dual

application firmware consisting of the Reflector Client and the more complex Barix STL

application.

The Exstreamer 500/1000 are delivered with the STL firmware preloaded, but any Barix

audio hardware can run the firmware, subject only to limitations of the hardware

(Instreamers cannot be decoders, for example). This guide is for the Reflector firmware,

there is a manual for the STL Application available from www.barix.com/downloads where

the firmware can also be found. The firmware is delivered as a zip file which contains a

“_readme1st.txt” file that explains how to load the firmware into the hardware.

All devices to be used must have the firmware loaded and be active in 'Reflector' mode.

The same firmware is loaded onto the Sending and Receiving devices

When loading the firmware, take a note of the MAC addresses, you will need them later:

 t's on the top line of the UI, to the right in the picture below

 it's physically written on the underside of the device

Once loaded, to switch between the two applications, simply navigate to the 'Reboot' page

of the Client web UI and select to 'reboot as' the application you want:

Barix Reflector User Guide.doc Page 6 of 22

1 2 3 4 5 6 7 8 9 10 11 ... 21 22

Sem comentários

BARIX Streaming Client Guia do Utilizador Página 6