BARIX Streaming Client Manual do Utilizador descarregar pdf (Página 12)

Gateway IP Address

A correct setting of the Gateway IP address is needed to stream to the Internet or to destinations

outside your local network (LAN).

Enter the 4 values of the desired Gateway IP address e.g.:

• "0.0.0.0" for no Gateway or automatic discovery

• "192.168.0.1" for a Gateway in a LAN

Note: If you have set the devices IP address to automatic discovery and your server or router has

issued an IP address then most probably it also has supplied a valid Gateway address, “0.0.0.0”

will then work ﬁne.

If you have set a SonicIP address then you will need to conﬁgure a valid Gateway address manually.

Try ﬁrst the same Gateway IP address your PC is set to. If it doesn’t work then ask your Network

Administrator for a correct Gateway IP address.

Primary/Alternative DNS

In these fields you can provide DNS IP addresses which are used to resolve URLs, e.g.

www.radio.com

DHCP Host Name

From version VB3.17 a DHCP host name can be conﬁgured for the device. If this ﬁeld is left blank

then the device creates a DHCP name using part of the Ethernet MAC address e.g.“CO1ED04”

where ED04 are the 2 least signiﬁcat bytes of the MAC.

Use SonicIP

If “Use SonicIP” is set to yes, the device will announce its IP address over the audio output during

start up.

3.2 Audio settings

This chapter explains how to adjust the audio input and output settings of the Barix device.

Input source

Choose the desired input source. Line mono and MIC input are mono, the other settings are

stereo.

The options available depend on the HW according to the table below. The Exstreamer 500 and

12 Device Conﬁguration

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 34 35

Sem comentários

BARIX Streaming Client Manual do Utilizador Página 12